Numerical values may alsoĭiameter of the virtual “pen” that draws the two arcs of theĬurve’s outline, which intersect at the endpoints. Otherwise, it determines whether the object is placed LEFT, CENTER or RIGHT with respect to the X), then this property determines whether the object is placed Looking at the top of the Internals Reference page for each interface More information on the allowed parameters for a grob can be found by Each dash-element has a starting t value,Īn ending t-value, a dash-fraction, and a dash-period.Īlist of parameters for detailed grob behavior. This should list the control points of a third-order Bézier curve.ĭash structure. Vertical position (such as accidentals, clefs, etc.), outsideĬontrol points for the tie, slur, or bracket shape. In grobs whose notational significance depends on Outside of the slur only if there is a collision. inside adjusts the slur if needed to keep the User settable properties: avoid-slur (symbol) Variations differ in their initial vertical position by half a staff-space. The number of variations that are tried for the extremal ties in a chord. Successive candidates differ in their initial vertical position by half a staff-space. The number of candidate ties to generate when only a single tie is required. Padding of the skylines around note heads in chords. Outer-tie-vertical-distance-symmetry-penalty-factorĭemerit factor for ties vertically positioned unsymmetrically with respect to the two note heads.Īmount (in half staff-spaces) by which a tie is moved away from the note heads if it is closer to either of them than 0.25 half staff-spaces. If the tie’s height (in half staff-spaces) is less than this it is positioned between two adjacent staff lines otherwise it is positioned to straddle a staff line further from the note heads.ĭemerit factor for ties horizontally positioned unsymmetrically with respect to the two note heads. If this tie is closer than this amount to the previous tie in the set being considered, an increasingly large tie-tie collision penalty is incurred.ĭemerit factor for a tie in the set being considered which is close to the previous one.ĭemerit factor for ties in the set being considered which are horizontally distant from the note heads.ĭemerit factor for ties in the set being considered which are vertically distant from the note heads.ĭemerit if tie is on the same side as a stem or on the opposite side to the one specified. The distance (in staff-spaces) by which the ends of the tie are offset horizontally from a stem which is on the same side of the note head as the tie.ĭemerit if the y-position of this tie in the set of ties being considered is less than the y-position of the previous tie. The distance (in staff-spaces) by which the ends of the tie are offset horizontally from the center line through the note head. If the tie comes closer to a dot than this amount, an increasingly large dot collision penalty is incurred.ĭemerit factor for ties which come close to dots. If the tips of the tie are closer to a staff line than this amount, an increasingly large staff line collision penalty is incurred.ĭemerit factor for ties whose tips or center come close to staff lines. If the center of the tie is closer to a staff line than this amount, an increasingly large staff line collision penalty is incurred. If the tie is shorter than this amount (in staff-spaces) an increasingly large length penalty is incurred.ĭemerit factor for tie lengths shorter than min-length. The higher this number, the quicker the slur attains its height-limit.ĭemerit for ties that are offset in the wrong direction. The following properties may be set in the details list. A tie - a horizontal curve connecting two noteheads.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |